Skip to content
City of Fruita

Community Center Second Floor Bathroom Addition

Solicitation: RFP-COF-3-26
Notice ID: 58a68036216012f6b38688af4a4bead4
DepartmentCity of FruitaStateCOPostedMar 09, 2026, 12:00 AM UTCDueMay 04, 2026, 12:00 AM UTCCloses in 51 days

Federal opportunity from City of Fruita. Place of performance: CO. Response deadline: May 04, 2026.

Market snapshot

Baseline awarded-market signal across all contracting (sample of 400 recent awards; refreshed periodically).

12-month awarded value
$749,153,672
Sector total $749,153,672 • Share 100.0%
Live
Median
$191,909
P10–P90
$26,352$2,547,835
Volatility
Volatile200%
Market composition
NAICS share of sector
A simple concentration signal, not a forecast.
100.0%
share
Momentum (last 3 vs prior 3 buckets)
+100%($749,153,672)
Deal sizing
$191,909 median
Use as a pricing centerline.
Live signal is computed from awarded notices already observed in the system.
Signals shown are descriptive of observed awards; not a forecast.

Related hubs & trends

Navigate the lattice: hubs for browsing, trends for pricing signals.

We write these bids →
Open on official portal →
Live POP
Place of performance
CO, US
State: US
Contracting office
Not listed

Applicable Wage Determinations

SAM WDOL references matched to this opportunity's location and scope language.

WD Directory →
Best fit for this contractDavis-Bacon
CO20260014 (Rev 0)
Match signal: state matchOpen WD
Published Jan 02, 2026Colorado • Larimer, Mesa, Weld
Rate
POWER EQUIPMENT OPERATOR: (3)- Drill Rig Caisson (smaller than Watson 2500 and similar)
Base $35.03Fringe $15.20
Rate
Oiler Weld County
Base $35.20Fringe $15.20
+95 more occupation rates available in the full WD.
View more for this contract
3 more WD matches and 95 more rate previews.
Davis-BaconBest fitstate match
CO20260014 (Rev 0)
Open WD
Published Jan 02, 2026Colorado • Larimer, Mesa, Weld
Rate
POWER EQUIPMENT OPERATOR: (3)- Drill Rig Caisson (smaller than Watson 2500 and similar)
Base $35.03Fringe $15.20
Rate
Oiler Weld County
Base $35.20Fringe $15.20
Rate
Drill Rig Caisson (Watson 2500 similar or larger)
Base $35.41Fringe $15.20
+94 more occupation rates in this WD
Davis-Baconstate match
CO20260030 (Rev 0)
Open WD
Published Jan 02, 2026Colorado • Elbert, Gilpin
Rate
CARPENTER (Acoustical Ceiling Installation and Drywall Hanging Only)
Base $35.09Fringe $13.84
Rate
MILLWRIGHT
Base $42.10Fringe $19.02
Rate
ELECTRICIAN (Includes Low Voltage Wiring)
Base $46.80Fringe $19.53
+30 more occupation rates in this WD
Davis-Baconstate match
CO20260029 (Rev 0)
Open WD
Published Jan 02, 2026Colorado • Weld
Rate
ELECTRICIAN
Base $46.80Fringe $19.53
Rate
POWER EQUIPMENT OPERATOR (Crane) 141 tons and over
Base $39.80Fringe $15.20
Rate
tons and under
Base $35.78Fringe $15.20
+22 more occupation rates in this WD
Service Contract Actstate match
2023-0171 (Rev 8)
Open WD
Published Jan 20, 2026Colorado • Larimer
47040
Diver
Base $53.87Fringe $0.00

HEALTH & WELFARE: $5.55 per hour, up to 40 hours per week, or $222.00 per week or $962.00 per month HEALTH & WELFARE EO 13706: $5.09 per hour, up to 40 hours per week, or $203.60 per week, or $882.27 per month* *This rate is to be used only when compensating employees for performance on an SCA- covered contract also covered by EO 13706, Establishing Paid Sick Leave for Federal Contractors. A contractor may not receive credit toward its SCA obligations for any paid sick leave provided pursuant to EO 13706. | VACATION: 2 weeks paid vacation after 1 year of service with a contractor or successor; 3 weeks after 5 years, 4 weeks after 10 years, and 5 weeks after 15 years. Length of service includes the whole span of continuous service with the present contractor or successor, wherever employed, and with the predecessor contractors in the performance of similar work at the same Federal facility. (Reg. 29 CFR 4.173) | HOLIDAYS: A minimum of eleven paid holidays per year: New Year's Day, Martin Luther King Jr.'s Birthday, Washington's Birthday, Memorial Day, Juneteenth National Independence Day, Independence Day, Labor Day, Columbus Day, Veterans' Day, Thanksgiving Day, and Christmas Day. (A contractor may substitute for any of the named holidays another day off with pay in accordance with a plan communicated to the employees involved.) (See 29 CFR 4.174) ** UNIFORM ALLOWANCE ** If employees are required to wear uniforms in the performance of this contract (either by the terms of the Government contract, by the employer, by the state or local law, etc.), the cost of furnishing such uniforms and maintaining (by laundering or dry cleaning) such uniforms is an expense that may not be borne by an employee where such cost reduces the hourly rate below that required by the wage determination. The Department of Labor will accept payment in accordance with the following standards as compliance: The contractor or subcontractor is required to furnish all employees with an adequate number of uniforms without cost or to reimburse employees for the actual cost of the uniforms. In addition, where uniform cleaning and maintenance is made the responsibility of the employee, all contractors and subcontractors subject to this wage determination shall (in the absence of a bona fide collective bargaining agreement providing for a different amount, or the furnishing of contrary affirmative proof as to the actual cost), reimburse all employees for such cleaning and maintenance at a rate of $3.35 per week (or $.67 cents per day). However, in those instances where the uniforms furnished are made of ""wash and wear"" materials, may be routinely washed and dried with other personal garments, and do not require any special treatment such as dry cleaning, daily washing, or commercial laundering in order to meet the cleanliness or appearance standards set by the terms of the Government contract, by the contractor, by law, or by the nature of the work, there is no requirement that employees be reimbursed for uniform maintenance costs. ** SERVICE CONTRACT ACT DIRECTORY OF OCCUPATIONS ** The duties of employees under job titles listed are those described in the ""Service Contract Act Directory of Occupations"", Fifth Edition (Revision 1), dated September 2015, unless otherwise indicated.

Point of Contact

Not available

Agency & Office

Department
City of Fruita
Agency
Not available
Subagency
Not available
Office
Procurement
Contracting Office Address
Not available

Description

The City of Fruita is requesting proposals from qualified contractors for the design and construction of a single American with Disabilities Act of 1990 as enacted and amended from time to time (“ADA”) accessible restroom on the second floor of the Fruita Community Center (FCC). ). The restroom will be located within the existing fitness studio storage room. As part of this project, the fitness studio storage area will be reconfigured to accommodate the new restroom, including the installation of new double doors to provide appropriate access to the redesigned storage space.A mandatory Pre-Proposal walkthrough of the Community Center and Project (defined below) area will be conducted by City and held for prospective Offerors on Tuesday, March 24, 2026, at 10:30 a.m. (MDT) at the Community Center located at 324 N. Coulson Street, Fruita, Colorado 81521. Offerors acknowledge and understand the obligation to attend such walkthrough before submitting a Proposal.Proposals must be submitted and received by City on or before 2:30 PM on May 4, 2026. Electronic Proposals will be accepted through ’s Rocky Mountain E-Purchasing System (“RMEPS”). https://www. .com/colorado. (City does not have access to or control over the vendor side of RMEPS, and City makes no representation or warranty concerning the operability or accessibility of RMEPS. If website accessibility or operability or other problems with RMEPS arise during Proposal submission, the Offerors MUST contact to resolve the issue prior to the Submission Deadline. The Submission Deadline will not be changed or extended due to any issues or problems with Proposal submission, through RMEPS or otherwise. Should any such issues or problems arise, contact at 800-835-4603.)

Files

Files size/type shown when available.

BidPulsar Analysis

A practical, capture-style breakdown of fit, requirements, risks, and next steps.

Analysis is being generated for this notice. Check back shortly.

FAQ

How do I use the Market Snapshot?

It summarizes awarded-contract behavior for the opportunity’s NAICS and sector, including a recent pricing band (P10–P90), momentum, and composition. Use it as context, not a guarantee.

Is the data live?

The signal updates as new awarded notices enter the system. Always validate the official award and solicitation details on SAM.gov.

What do P10 and P90 mean?

P10 is the 10th percentile award size and P90 is the 90th percentile. Together they describe the typical spread of award values.